DAGU Micro Magician arduino robot controller 3.6V to 9V ATmega168/ATmega328 MCU 8MHz ROHS

Brands DAGU
Product Code: RS019
Availability: 999

The micro Magician robot controller is the perfect choice for small/low voltage robot projects.

It can be programmed using a USB cable and the Arduino IDE, which is free from the internet.

The controller comes with the LillyPad(168) bootloader.


Each unit comes pre-assembled and tested. Supplied in an anti-static bag with additional mounting post to  chassis's.


The Micro Magician robot controller is the perfect choice for small / low voltage robotprojects.

This low cost Arduino compatible controller is packed full of features:

· Small size of just 60mm x 30mm

· Supply voltage from 3.6V to 9V with 3.3V regulator and reverse polarity protection

· ATmega168 or ATmega328 MCU at 8MHz

· Dual 1A FET “H” bridge with electronic braking, current limiting and overload detect

· 3 axis accelerometer with 0G detection and either 1.5G or 6G full range sensitivity

· 38KHz IR receiver with signal detection LED

· Up to 8 servos can plug directly into the controller when V+ is set to Battery

· 3.3V and GND outputs available for powering sensors

· All I/O pins (except D4) have both male and female header pins

· Status LEDs for Power, RX, TX, IR signal and D13.

Write a review

Note: HTML is not translated!
    Bad           Good