Your Cart

3D DIY wooden kit

3D DIY wooden kit
TT gear motor: reduciton ratio 1:220, single side, double male lead;Battery holder: 2*AAA, red and black double female lead 15cm;Toggle switches: wire 10cm, female-male​Screwdriver..
Including:4*DC gear motor4*wheels1*4AA battery holder4*20 line tachometer encoder8*Fastener1*3D assembly drawings1*Several pillars screw nut1*boxonly the above package content, other products are not included...
1. suitable for arduino UNO Board, Quick Disassembly, Simple and Convenient2. Input voltage range: 6V-12.6V, it can provide 3.6A maximum current, which can support multiple steering motors to ensure normal operation.3. On-board high performance continuous current 3A (peak output current 5A) H bridge..
Motion in the ComMotionControlling 4 motors, reading their encoders, monitoring their current draw requires a lot of processor pins so the first thing I did was to make the shield I²C controlled.This way only two pins were needed leaving all the other pins free for use with other shields, circuits o..
1, MCU: ATmega32U4, more internal resources2, input voltage range: 6V-12.6V, LM2676 can provide up to 3.6A current, can support multiple servos to ensure normal operation3, onboard high performance dual 5A integrated H-bridge motor driver External PWM control signal, high temperature automatic prote..
Power input: +20V - +7VPower output: 5V/1A, 5V/5A, 3.3V/1AControl steering gear channel: 24Communication input: TTLActuator drive resolution: about 5US, about 0.45 degreesBaud rate setting: 115200Driving pulse range: 2500 - 500 Hardware protection:A)dual power supply voltage, one for the power supp..
Features:1.Pin configuration is compatible with S4A (V1.5).2.Arduino Pro Mini 328 5V 16mhz Bootloader.3.ATmega328P processor @ 16MHz with 32K FLASH, 2K SRAM and 1K EEPROM.4.Dual motor driver rated at 2.5A per motor.5.Motor controller pins can be isolated and used as standard digital and PWM pins.6...
MCU: ATmega8A, Frequency: 16MHZInput voltage range: 5.4V ~ 9VLow dropout voltage: 250mV @ 500mA, 450mV @ 1AOnboard high-performance dual 2A independent MOSFET H-bridge motor driverAn external PWM control signalBluetooth module interface (standard Otani Electronics Bluetooth module) can be used wit..
The micro Magician robot controller is the perfect choice for small/low voltage robot projects.It can be programmed using a USB cable and the Arduino IDE, which is free from the internet.The controller comes with the LillyPad(168) bootloader. Each unit comes pre-assembled and tested. Supplied in an..
DESCRIPTION: The T’Rex controller from DAGU is an Arduino compatible robot controller designed to power and control servos and brushed motors. This controller combines an Arduino development board with a dual FET H-bridge motor driver. The heart of the board is an ATMega328P AVR microcontroller whic..
Product Parameters: ATmega2560 16MHz CPU 256K flash memory, 8K SRAM and 4K EEPROM USB interface and ISP socket (CP2102)  Built in 3A switch mode power supply 70 I/O pins with male and female headers Support for up to 48 servos 16x 10bit analog inputs 15x 8bit PWM outp 1xI2C ..
This useless box is the wooden version.Every time you press the switch, this box will open automationcally.This kits include assemble instruction and tools.You can enjoy the process when you assemble...
Showing 1 to 15 of 15 (1 Pages)